Luen Hing Electrical（HK）Limited

Cambridge Audio AXR-85 Stereo Amplifier 85W

數量

簡介

+ Product Features: - The Cambridge Audio AXR85 stereo receiver delivers 85 watts x 2 channels into 8-ohms, 20-20kHz with 0.15% THD. The built-in AM/FM tuner provides manual, seek & preset tuning. You can store up to 15 FM & AM presets each. You can select between Stereo or Mono when listening to FM; for low quality stereo FM signals, selecting mono can usually reduce the noise. There is 75-ohm FM connector & a 300-ohm two-wire AM connector on the receiver back-panel. A FM wire antenna & AM loop antenna are included - The Cambridge Audio AXR85 features built-in Bluetooth 5.0 with support for wireless audio streaming (A2DP) & control (AVRCP). You'll be able to wirelessly stream stored music, music apps, & other audio content on your Bluetooth-enabled source device to the AXR85 stereo receiver. You'll also be able to control basic playback functions, such as Play/Pause and Previous/Next Track from the included remote. The receiver can pair with up to 8 devices, but only one can be used for playback at a time - The Cambridge Audio AXR85 has a built-in Phono preamplifier (Phono Stage) with a rear-panel phono input and ground terminal. The phono input supports turntables outfitted with Phono Cartridges of the Moving Magnet (MM) or high output Moving Coil (MC) type (between 2-6mV output and 30-50k load impedance). The Ground terminals on both the AXR85 stereo receiver and your turntable should be connected (where possible) with a ground wire for lowest noise/hum pickup. - The Cambridge Audio AXR85 is equipped with a A & B speaker terminals for connecting up to two pair of loudspeakers or bi-wiring a single pair of loudspeakers. These binding post terminals will accept bare wire (up to 12AWG), pin-connectors, and banana plugs (single or dual). When connecting a single pair of speakers you can use 4-ohm to 8-ohm compatible speakers. When connecting two pair of loudspeakers or when bi-wiring a single pair of loudspeaker use only 8-ohm compatible speakers. - The Cambridge Audio stereo receiver is equipped with a mono-RCA subwoofer output for connecting a powered subwoofer. There is a USB-A (5V/500mA) port located on the back of the AXR85 stereo receiver that can be used to charge your smartphone or tablet, or supply power to a audio adapter. This USB port does not support audio playback. You'll be able to adjust Bass (100Hz) & Treble (20kHz) from -10 to +10dB, as well as adjust the balance in sound output between the connected left & right speaker
CambridgeAudio

你可能感興趣的商品